Scilox BL100 Bedienungsanleitung PDF herunterladen (Seite 14)

BL100 User Manual

- 7 -

2.2 Enroll an Administrator User

The deadbolt has two kinds of users: “Administrator User” and “Ordinary User”. If

the deadbolt has no Administrator User, then you can’t enroll Ordinary Users. You

must at least enroll one Administrator User before enrolling any Ordinary Users. To

enroll an Administrator User, enter Management Mode by following below:

1. Press button to start deadbolt, and then enter the “Verify State”.

2. Press and hold the button until you hear 1 long beep, enter the 5 digit

MPC, and then press button to enter the “Management Mode”.

3. Press "9" on the deadbolt to enter the “Enroll Administrator User” mode.

The next step is to register fingerprint(s) and PIN code for administrator.

2.2.1 Enroll an Administrator User’s Fingerprint

Note: Steps 1-3 are above.

4. After you enter the “Enroll Administrator User” mode, enter a 3 digit user

ID, and then press button to confirm.

Note: The Administrator User's ID must be between "995" and "999".

5. Press finger on the fingerprint sensor properly (For details, see 1.5 Finger

Placement), and remove once you hear a beep, repeat 2 additional times

(total 3 three times), until you hear one long beep and LED turns green.

Note: During the fingerprint registration process, if the fingerprint sensor

successfully registers the fingerprints, the button will turn green. If not, try

repeating the registration process with a different finger.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 30 31

Keine Kommentare

Scilox BL100 Bedienungsanleitung Seite 14