Scilox BL100 Bedienungsanleitung PDF herunterladen (Seite 17)

BL100 User Manual

- 10 -

2.3.2 Enroll an Ordinary User’s PIN Code

1. Press button to start the deadbolt and enter the “Verify State”.

2. Enter the “Management Mode”, (see step 2 in 2.3.1 Enroll an Ordinary User’s

Fingerprint).

3. Press "2" on the deadbolt to enter the “Enroll Ordinary User's PIN Code” mode.

4. Enter a 3 digit User ID, and press button to confirm.

Note: The Ordinary Users' ID must between "001" and "994".

5. Enter a 4 digit user PIN, press key to confirm. Enter the same 4 digit user

PIN once again and press key to confirm until you hear one long beep and

the LED flashes green. The keypad’s blue LED will turn off. If it fails to register - it

will give 2 short beeps and the LED will flash red.

Note:

(1) If PIN code does not match, the deadbolt will fail registration. In this case, you

will need to follow step 1 to 5 again.

(2) If successful, the deadbolt will automatically exit the “Enroll Administrator User

Mode”.

(3) You can press and hold "0" key to cancel operation and exit anytime.

(4) If you want to enroll more Ordinary Users, then repeat the step 1-5.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 30 31

Keine Kommentare

Scilox BL100 Bedienungsanleitung Seite 17