Scilox BL100 Bedienungsanleitung PDF herunterladen (Seite 15)

BL100 User Manual

- 8 -

2.2.2 Enroll an Administrator User PIN code

Note: Steps 1-3 are same as before (2.2)

4. After you enter the “Enroll Administrator User” mode, enter the 3 digit

user ID, press button to confirm.

5. Enter a 4 digit user PIN code and press button to confirm, and

then enter the same 4 digit user PIN code once again and press .

button to confirm, you will hear one long beep and LED turns green (if it

fails to register – it will give 2 short beeps and LED will flash red instead).

Note:

(1) If the deadbolt fails to register a finger, it will give 2 short beeps and the .

will flash red. If you are unable to register, you can try again for two more times.

(2) If the deadbolt registers a finger successfully, the deadbolt will automatically

exit the “Enroll Administrator User” mode.

(3) You can press and hold "0" key to cancel operation and exit at any time.

(4) If you want to enroll more Administrator Users, then repeat steps 1-5.

Note:

(1) If PIN code does not match, the deadbolt will fail registration. In this case, you

will need to follow step 1 to 5 again.

(2) If successful, the deadbolt will automatically exit the “Enroll Administrator

User” mode.

(3) You can press and hold "0" key to cancel operation and exit anytime.

(4) If you want to enroll more Administrator Users, then repeat the step 1-5.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 30 31

Keine Kommentare

Scilox BL100 Bedienungsanleitung Seite 15