Scilox BL100 Bedienungsanleitung PDF herunterladen (Seite 18)

BL100 User Manual

- 11 -

2.4 User Verification

The users can use fingerprint or PIN code verification to unlock the deadbolt.

2.4.1 Fingerprint Verification

1. Press button to start the deadbolt and enter the “Verify State”. The

fingerprint sensor is in a “Ready State”.

2. Press finger on the fingerprint sensor properly (For detail, please see 1.5 Finger

Placement), until you hear one long beep.

(1) If verification is successful, the deadbolt will sound a long beep and

deadbolt will unlock, the button will flash green for 3 seconds,

the fingerprint sensor will flash green for 5 seconds.

(2) If verification failed, the deadbolt will sound two short beeps, the .

button will flash red for 3 seconds, and then the green LED will flash. The

user can use their fingerprint to verify again until verification is successful.

2.4.2 PIN Code Verification

1. Press button to start the deadbolt and enter the “Verify State”.

2. Enter the programmed 4-digit PIN code and press button to confirm.

(1) If verification is successful, the deadbolt will sound a long beep and unlock,

the button will flash green for 3 seconds, the fingerprint sensor

will flash green for 5 seconds.

(2) If verification failed, the deadbolt will sound two short beeps, the .

button will flash red for 3 seconds, and then the LED will flash green.

The user can use PIN code to verify again until verification is successful.

Note: After successful verification, the deadbolt is unlocked. Press -

button again to lock and power off the deadbolt.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 30 31

Keine Kommentare

Scilox BL100 Bedienungsanleitung Seite 18